Clue #1 Vertical/Portrait card, Gather your supplies:
Colored Card Stock: card base – 1 @ 4-1/4 x 5-1/2 – 1 @ 3-1/8 x 6, score at 1/2 from one end on the long side. Adhere to the top of the card base keeping the fold inside the card. Can be centered, left or right.
DSP: – 1 @ 5-1/2 x 3. Adhere over the outside of the 3-1/8 flap, leaving only narrow edges on the sides, not the top or bottom.
White/Vanilla Card Stock (CS): – 1 @ 3 or 3-1/8 (your choice) x 5-1/2 (writing panel). Goes under the front panel and over the flap, completely covered by the panel.
Embellishments: – for embellishments, use something that goes along with your DSP
I hope you like this fun-fold card! Please join us if you like to make a card without knowing what it is until you are done!!
This card was for my faithful Monday Night Mystery Stampers! Join us and you, too will get extra perks! I hope you like this fun-fold card! Please join us if you like to make a card without knowing what it is until you are done!!
I really like this card for using DSP and a nice focal panel.
Clue #1 Vertical/Portrait card, Gather your supplies:
Colored Cardstock: – 1 @ 5-1/2 x 6-3/8, score on the long side at 4-1/4
– 1 @ 3-1/2 x 4, score at 2 on the long side, attach on the outside flap of the card base, putting the fold over the edge of the card base BEFORE adding DSP
Coordinating Colored Card Stock: – 1 @ 3-1/4 x 3-3/4, layer this onto the 3-1/2 x 4 piece above, with adhesive ONLY on the bottom half
Designer Series Paper (DSP): – 1 @ 1-7/8 high x 5-1/4 wide – 1 @ 1-1/2 high x 5-1/4 wide, layer this on the 5-1/4 x 4 White/Vanilla piece, attach inside card
White/Vanilla Card Stock (CS): – 1 @ 5-1/4 x 4 – 1 @ 3 x 3-1/2, This is your focal point. It is 3 wide and 3-1/2 tall.
Embellishments small to medium: use something that goes along with your DSP and something small to make the front panel stand up and it folds flat to mail
I hope you like this fun-fold card! Please join us if you would like to make a card without knowing what it is until you are done!!
This card can be made with or without the layers. Maybe make one with all of the layers and then you can choose to do it differently for the next card. You can do a scenic DSP or a variety of patterns. Probably not too large a pattern.
Vertical/Portrait card: Clue #1… gather your supplies, All measurements in inches.
Base (A): white or color depending on your DSP choice – 1 @ 4-1/4 X 11 – Score long side @ 5-1/2 (This piece can be optional if you use lots of layers or you want a lot of space to write. You can decide after you make the rest of the card.) Colored Card Stock (B): – 1 @ 4-1/8 x 5-3/8 (1st layer on base) Colored Card Stock (C) – 1 @ 5-1/8 x 5-1/4 (Score with 5-1/4 @ top @ 1-1/4, 2, 3-1/4, 4)- 1 @ 1-1/4 x 3 (Cross Bar OPTIONAL) Colored Card Stock (D): These are layers: – 3 @ 1 x 5 – 2 @ 5/8 x 5 – 1 @ 1-1/8 x 2-7/8 (Cross Bar OPTIONAL) Designer Series Paper (DSP): – 3 @ 7/8 x 4-7/8- 2 @ 1/2 x 4-7/8 – 1 @ 1 x 2-3/4 (Cross Bar OPTIONAL)
I hope you like this fun-fold card! Please join us if you like to make a card without knowing what it is until you are done!!
Vertical/Portrait card: Clue #1… gather your supplies, All measurements in inches. A really pretty card suggested by Arlesia.
This card has the opportunity to use 3 different DSPs. I would use something appropriate for the size of each mat. The largest piece of DSP will have a writing panel over much of it.
Cardstock Base A: 1 @ 5-1/2 x 8-1/4, NOTE: NOT 8-1/2 but 8-1/4, score at 1, 2, 3, 4 from one edge 1 @ 4-1/8 x 2-7/8 1 @ 4-7/8 x 3-5/8 DSP: 1 @ 5-1/4 tall x 4 wide 1 @ 3-7/8 x 2-5/8 1 @ 4-5/8 x 3-3/8 Basic White or Very Vanilla: 1 @ 4-1/4 x 3 Focal point: Die cut(s) and sentiments for 2 or 3 panels.
On the edge of the card base closest to the 1″ fold, lightly mark on the edge at 2-3/4 up from the bottom. Cut from that mark to the top of the 4″ score at the top of the card. Fold the base mountain, valley, mountain, valley. Adhere the smallest cardstock panel to the frontmost fold, lining up edges. Adhere the other card stock panel to the next mountain fold, making sure the panel is not obstructing the fold.
**NOTE: If you do not like measuring eighths of an inch, follow these measurements 1 @ 5-1/2 x 8-1/4, NOTE: NOT 8-1/2 but 8-1/4, score at 1, 2, 3, 4 from one edge 1 @ 4 x 2-3/4 1 @ 4-3/4 x 3-1/2 DSP: 1 @ 5-1/4 tall x 4 wide 1 @ 3-3/4 x 2-1/2 1 @ 4-1/2x 3-1/4 Basic White or Very Vanilla: 1 @ 4-1/4 x 3
This photo shows how the panels line up with these measurements. Before you adhere the 2 panels, slide them up to cover the 2 little triangles.
Adhere the panels, hiding the 2 triangles, open the card and trim off 1/8″ across the entire bottom of the card.
My cards aren’t quite completed, but here they are to give you a couple of ideas.
I hope you like this fun-fold card! Please join us if you like to make a card without knowing what it is until you are done!!
Vertical/Portrait card: Clue #1… gather your supplies, All measurements in inches.
Get ready to dig through your paper stash!! You don’t need full quarter sheets for these cards! Yes, these, we are making 3 cards in a very short time! The key to these cards is your DSP. I would use double-sided and mostly non-directional with 2 smallish patterns and 1 maybe medium. You can use 3 smallish patterns, too.
Clue #1 … Gather your supplies: All measurements in inches. This is a portrait/vertical card.
Cardstock Base A: Based on your DSP. Can be the same or different. 3 @ 5-1/2 x 8-1/2, scored at 4-1/4 Cardstock B:Based on your Card base and DSP choices. Can be the same or different. 3 @ 5-1/4 x 4 DSP: Double-sided DSP is probably best. 3 @ 4-3/4 tall x 3-3/4 wide Basic White or Very Vanilla: 1 @ 5 x 4-1/4 for the inside if your card base is dark Focal point: I would add a sentiment for the front of the card. OPTIONAL: Die cut(s)
Stack all 3 pieces of your DSP together and mark the top sheet as shown below. Then cut on the lines from side to side.
Here are my 3 cards with the 3 patterns. You can see each one is at the top, middle and bottom on the 3 cards.
You can also turn over the DSP if there is a pattern there that you like better.
I hope you like this fun-fold card! Please join us if you like to make a card without knowing what it is until you are done!!
Vertical/Portrait card: Clue #1… gather your supplies, All measurements in inches.
Cardstock Base A: 1 @ 5-1/2 x 11 scoring along the 11″ side from left to right: 1-1/4, 5-1/2, 9-1/4 1 @ 1-1/4 x 10 optional: 2-3/4 square to back sentiment or die cut(s)
DSP: can be scenic, 3 or 4 complimentary patterns, all one pattern 1 @ 7 1/2 wide x 5 1/4 tall, cut from left to right: 1, 1, 4, leaving 1-1/2 1 @ 1-1/8 x 10
Basic White or Very Vanilla: 1 @ 5-1/4 x 3-1/2 optional: 2-1/2 square for your sentiment
I hope you like this fun-fold card! Please join us if you like to make a card without knowing what it is until you are done!!
Vertical/Portrait card: Clue #1… gather your supplies, All measurements in inches.
Cardstock Base A:1 @ 5-1/2 x 4-1/4 Cardstock B: (this can be foil or anything else to back the white square and compliment the DSP) 1 @ 2-7/8 x 2-7/8DSP: Double-sided DSP is a must for this card. 1 @ 12 wide x 5-1/4 tall Basic White or Very Vanilla: 1 @ 5 x 3-3/4 1 @ 2-3/4 x 2-3/4 Focal point: Die cut(s) and sentiment for the front of the card. The focal piece is the 2-3/4 square turned on a point.I hope you like this fun-fold card!
Please join us if you like to make a card without knowing what it is until you are done!!